Norcold DC0788B - Protection System

5
Check if the voltage noted on the type plate on the refrigerator
matches the one applied by an external power source.
The refrigerator temperature is controlled by a thermostat, located in the
refrigerator. A light, located on the panel comes on when the refrigerator is “ON”.
Number “1” is the warmest and number “5” is the coldest thermostat position. For
efcient operation, change the thermostat according to the types of food stored and
the ambient temperature.
If you are not going to use the refrigerator for an extended period of time, put the thermostat
to the “OFF” position (full counterclockwise position).
Protection System
Your refrigerator has an over current protection system in the electronic circuit to
prevent damage to the inverter which may occur due to a reverse polarity connection.
If the refrigerator does not operate and the interior light does not come on, check
the fuse, which is located on the side of the inverter case, and the polarity of the DC
power supply. If the refrigerator still does not operate, another problem can exist in the
inverter. Have an authorized Norcold Service Center check the refrigerator.
Cleaning and Defrosting
Defrosting
It is normal for frost to collect on the freezer plate inside the refrigerator. Excess frost
decreases the cooling performance of the refrigerator. Defrost the refrigerator as
necessary.
Do not use sharp objects, a hair dryer, a heat gun, etc.
to defrost the refrigerator. Damage to the interior of the
refrigerator can occur.
- Turn the thermostat to “OFF”.
- Remove all food from the refrigerator.
Defrosting the refrigerator makes excess water inside the refrigerator.
- Put dry towels (etc.) inside the refrigerator to absorb the excess water.
- Put trays of hot water in the freezer until the frost is melted.
- Empty the drip tray.
- Remove the wet towels (etc.) and dry the inside of the refrigerator
NOTICE
CAUTION
!
NOTICE