Owner’s Manual 7
- Touch the CABINET COMPARTMENT [6] button to set the compartment temperature setting.(ART 02775)
-Using the + [4] or – [2] buttons adjust the temperature setting.
- The mode [3] will display the temperature setting
- 1 is the warmest setting
- 5 is the coldest setting
- Press any button to return the control to activate mode, the mode [3] will
illuminate. The display will return to standby mode after 3 seconds.
-Touch the NIGHT MODE [7] button to set the refrigerator to night mode.
-Nightmodewillturnoautomaticallyaftereighthoursorifyoupushthenightmodebuttonagaintoturntheblueindicatorlighto.
- This 8 hour night mode setting can be changed by pressing the night mode button for 3 seconds. After the 3 seconds, the default 8
hours will be shown in the display . To change this setting, press the “+” or “-”, then press night mode button to make the setting go into
eect.
-The new setting is archived in the memory until it is changed.
-Toturnon/oDOORLEDholdtheCABINETCOMPARTMENT[8]buttonfor3seconds.
Shut down:
- To shut down the refrigerator, touch and hold the ON/OFF button [1] for 5 seconds and release.
- Once the refrigerator is turned OFF there is a 5 minute wait cycle before the compressor will turn ON.
Do not operate the refrigerator when the ambient temperature is above 140°F operation above recommend-
ed ambient temperatures can cause permanent damage to the compressor. Operation when the ambient
temperature is higher that 110°F can result in poor cooling performance.
DC Operation Guidelines:
The refrigerator gets DC power from the vehicle battery system. The battery system also supplies power to any other DC appliances or
accessories of the vehicle.
A dual battery system provides the best power usage. This system uses two batteries. One battery supplies DC power only to the
vehicle engine and its accessories. The second battery supplies DC power only to the DC appliances of the vehicle. An alternator,
powered by the vehicle engine, charges both of the batteries.
When an error occurs the display screen will blink an error code [3]. ( ART02776)
E1: Cabinet Thermistor Error
E2: Freezer Thermistor Error
E3: Low/high voltage cutout
E4: Cabinet door open (longer than 2 minutes)
E5: Voltage too low
E6: Ambient Thermistor Error
E7: Cabinet Fan Error
E8: Freezer Condenser fan failure
E9: Fresh Food Condenser fan failure
!
Error Codes
1
6
ART 02775
7
4
3
2
5
1
6
ART 02776
7
4
3
2
5
To Next Page
Loading...
Need help?
General
