New Thermocouple Installation
I uncoiled the new Thermocouple and straightened it out to its full length….54”. I inserted the
probe end into the burner box and routed the rest of it similarly to the old one and positioned the
upper end near the interrupter so that I could thread it into the interrupter opening. I snugged the
fitting gently but firmly. I installed three new cable ties in approximately the same position as the
old ones and the refrigerator was ready to go back into the coach. I would like to have tested the
refrigerator operation before reinstalling it. However, I did not have any means of supplying gas
to the refrigerator while it was out.
To Next Page
Loading...
