56
Check for transport damage after unpacking. Do not use a damaged cabinet. In the event of damage, please contact the
shipping company and make sure that the damage is noted on the consignment note. Check that you have all the parts on
the parts list at the back of this guide. Contact your vendor in the event of damage or missing parts.
The appliance must be connected to a 220V - 240V 50 Hz earthed electrical power supply with at least a 10A fuse. We
recommend placing the socket next to the product, for example in an adjoining unit.
This product is designed to be installed under a worktop, which must be fastened to the kitchen ttings and/or wall to ensure
that it does not tip forward when drawers are pulled out. This product cannot be used as a free-standing unit.
6. Pre-installation
7. Installation
The drawer fridge requires a space of 800mm. See g. 2.
Adjust the back levelling legs so that the back edge of the drawer fridge just clears the underside of the worktop. Extract
retaining brackets See g. 3.
Carefully slide the product into position and adjust the front legs so that the front edge squeezes rmly against the underside
of the worktop. Fasten the appliance to the worktop using two screws.
Space measurement Fig. 2
0
To Next Page
Loading...
