1
Introduction
The nRF5340 DK is a hardware development platform for designing and developing application firmware
on the nRF5340 System on Chip (SoC).
Key features
• nRF5340 SoC
• Support for the following wireless protocols:
• Bluetooth
®
Low Energy
• Near Field Communication (NFC)
• 802.15.4
• Thread
®
• Zigbee
®
• ANT
™
• 2.4 GHz proprietary
• Arduino Rev3 compatibility
• 2.4 GHz and NFC antennas
• Microwave coaxial connector with switch (SWF) RF connector for direct RF measurements
• User-programmable LEDs (4) and buttons (4)
• SEGGER J-Link OB programmer/debugger
• Two Universal Asynchronous Receiver/Transmitter (UART) interfaces through virtual serial ports
• Universal Serial Bus (USB) connection J2 to interface MCU for debugging/programming and power
• nRF-USB connection J3 to the nRF5340 application MCU and for power
• Pins for measuring power consumption
• Drag-and-drop Mass Storage Device (MSD) programming
• 1.7 V to 5.0 V power supply from USB, external Lithium-polymer (Li-Poly), or CR2032 coin cell battery
For access to firmware source code, hardware schematics, and layout files, see www.nordicsemi.com.
4406_638
6
To Next Page
