10
9. IMPORTANT: If the elliptical exerciser has
been exposed to cold temperatures, allow it
to warm to room temperature before plug-
g
ing in the Power Cord (55). If you do not do
this, you may damage the console displays
o
r other electronic components.
Plug the Power Cord (55) into the power socket
at the rear of the elliptical exerciser.
Note: When you plug in the elliptical exer-
ciser for the first time (see HOW TO PLUG
IN THE POWER CORD on page 11), the
Ramp (not shown) will calibrate automati-
cally. The Ramp will move upward and down-
ward as it calibrates. When the Ramp stops
moving, the Ramp is calibrated.
IMPORTANT: If the Ramp (not shown) does
not calibrate automatically, see HOW TO
CALIBRATE THE RAMP on page 21 and
manually calibrate the Ramp.
10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
9
55
To Next Page
Loading...
Need help?
General
