To Next PageTo Next PageHow to fix NordicTrack NTEL14416.3 if the console does not turn on?
If your NordicTrack Elliptical Trainer console isn't turning on, ensure the power cord is fully plugged in. Also, check that the power switch is in the reset position. Verify that the connectors on the wires are correctly oriented and firmly connected.
What to do if NordicTrack Elliptical Trainer console freezes?
If the console of your NordicTrack Elliptical Trainer doesn't boot properly or freezes, reset the console to the factory default settings.
Why NordicTrack Elliptical Trainer console does not display correct feedback?
If your NordicTrack Elliptical Trainer console isn't displaying correct feedback, try adjusting the reed switch.
What to do if NordicTrack NTEL14416.3 Elliptical Trainer pedals slip?
If the pedals on your NordicTrack Elliptical Trainer slip while pedaling, even at the highest resistance, the drive belt may need adjustment.
How to fix NordicTrack NTEL14416.3 Elliptical Trainer if the tablet holder does not stay in place?
If the tablet holder on your NordicTrack Elliptical Trainer doesn't stay in place, rotate it backward and tighten the screw (B) until it is secure.
General| Model | NTEL14416.3 |
|---|---|
| Type | Elliptical Trainer |
| Stride Length | 20 inches |
| Weight Capacity | 325 lbs |
| iFit Compatibility | Yes |
| Bluetooth Connectivity | Yes |
| Cooling Fan | Yes |
| Speakers | Yes |
| Warranty | 2-year parts, 1-year labor |
| Incline Range | 0-20% |
| Heart Rate Monitoring | Yes |
Warning to tighten the upright knob fully before each use to prevent injury.
Caution that user must support 100 lbs / 45 kgs to lower the elliptical.
Consult a physician before starting any exercise program, especially for those over 35.
Plug power cord into a grounded circuit; do not modify or use extension cords.
Do not use if weighing more than 325 lbs (147 kg).
Over-exercising can cause serious injury or death. Stop if faint, short of breath, or in pain.
Attach rear stabilizer to frame using specific screws, after removing shipping supports.
Attach front stabilizer to frame using specific screws, after removing shipping supports.
With help, raise upright to vertical position and tighten the upright knob.
Connect wires to console, insert excess wire into upright, and secure console with screws.
Attach upper body arms to legs using screws, ensure covers are flush. Repeat for other side.
Instructions on attaching the transmitter to the chest strap and positioning it on the body.
Plug power cord into a grounded outlet; do not modify or use extension cords.
Steps for folding and storing the elliptical, requiring two people and safe lifting.
Change pedal resistance and frame incline using console buttons or arm grips.
Select your network, enter password, and connect to your wireless network.
Solutions for console not turning on, heart rate display issues, or iFit connection problems.
Steps to reset the console to factory defaults to resolve freezing or boot-up issues.
