NordicTrack NTEVEL19016.2 - Page 8

8
7. See the inset drawing. Loosen the indicated
M8 x 45mm Bolt (124).
Next, rotate the Right Upper Body Arm (7) into
the vertical position.
Secure the Right Upper Body Arm (7) to the
Right Leg (5) with an M8 x 45mm Bolt (124) and
an M8 Locknut (123).
IMPORTANT: See the inset drawing. Tighten
the indicated M8 x 45mm Bolt (124).
Tip: Avoid pinching the wires (not shown).
Slide the Right Leg Cover B (36) downward and
press it into place.
Repeat this step on the other side of the
elliptical.
124
123
7
5
36
7
Avoid pinching
the wires
124
133
89
6
6. Identify the Left Pedal Arm (9). Using a plastic
bag to keep your fingers clean, apply a generous
amount of the included grease to the axle on the
Left Pedal Arm.
Then, insert the Left Pedal Arm (9) into the Left
Leg (6).
Attach the Left Pedal Arm (9) with an
M8 x 14mm Shoulder Screw (112), an
Outer Pedal Cover (133), and a Pedal Arm
Washer (89).
Attach the Right Pedal Arm (132) to the Right
Leg (5) in the same way.
9
132
5
112
Grease
6