• Remove barrel holder sleeve from holder. ò
• Loosen the 6 mm screw from T-nut. ù
• Slide T-nut into left or right panel of workstation
slot, positioning as shown. ä
• Tighten 6 mm screw, securing holder to workstation
panel. ë
• Insert barrel holder sleeve. ö
• Loosen screw from wire hose holder T-nut. ü
• Slide T-nut into any workstation slot. Å
• Tighten screw to secure wire hose holder to
workstation. î
Easy 13-Step Setup
Follow these steps to get your Ultimus ready
for operation.
Ultimus
™
I–II High Precision
Fluid Dispensers
• Connect the power plug to the power pack. The unit is shipped
with a USA-compatible plug and three international plugs. Attach
the correct plug to match local power outlets.
• Connect the power cord to the back of the Ultimus.
• Connect the power cord to your local power source.
• Press the power button on the front panel.
• Unpack the unit.
• Now is a good time to activate your Five* Year No-Fault Warranty.
Register the warranty online at www.nordsonefd.com/warranty/five-no-fault..
*Two years in Asia
Unpack the Unit / Warranty
1
Install Barrel Holder
2
Connect Power
3
Electronic pdf files of Nordson EFD manuals are also available at www.nordsonefd.com.
ò
ù
î
ä
ö
ü
Å
ë
Quick Start Guide
Power cord
To Next Page
Need help?
General
