Instruction Sheet
Part 1099054-02
E 2018 Nordson Corporation
P/N 1099054-02
Coolwave
r
2 Control Board
with Contactor Replacement Kit
NOTE: Retain the box used for shipping the control board and contactor to
comply with the conditions of warranty.
WARNING: Allow only qualified personnel to perform the following tasks.
Follow the safety instructions in this document and all other related
documentation. A qualified and competent electrician must carry out all
electrical maintenance and servicing of this equipment.
WARNING: This equipment operates at high voltages up to 5000 volts dc
and is therefore potentially dangerous. The electrician servicing this
equipment must take all precautions.
WARNING: Isolate the equipment at the main disconnect or lockout before
removing any of the cover panels.
New Control Board
See Figure 1. The fuses on the new control board are in different locations
than on the old control board.
Old Control Board
New Control Board
Fuses
Fuses
Figure 1 Old and New Versions of the Control Board
To Next Page
Need help?
General
