Nordson EPC-30 - Transducer Cable Wire Color Code

Series EPC-30 Current-to-Pressure (I/P) Transducer
3
Part 331276B
02
E 2010 Nordson Corporation
3. Use
5
/
16
-in. diameter (minimum) air line tubing to connect a clean, dry
air supply to the transducer air inlet port.
4. Connect
5
/
16
-in. diameter (minimum) air line tubing between the
transducer’s air outlet port and the hot melt unit.
5. Set the hot melt unit’s air pressure regulator at the maximum setting
(turn the regulator fully clockwise).
6. Route the transducer cable to the Eclipse EPC-30 pattern control. Refer
to the Eclipse EPC-30 pattern control manual for instructions on:
A. Connecting the transducer cable to the pattern control unit
The transducer cable wire color code information:
S natural lead wire is common or negative
S black lead wire is positive
B. Setting up and using the run-up control
5742119A
1
3
2
5
6
4
Figure 2 Transducer connections
1. Eclipse EPC-30 pattern control
2. Transducer cable
3. Elbow (air inlet port)
4. Elbow (air outlet port)
5. Air line tubing (air supply to
transducer)
6. Air line tubing (transducer to unit)