Series EPC-30 Current-to-Pressure (I/P) Transducer
4
Part 331276B
02
E 2010 Nordson Corporation
Troubleshooting
The following troubleshooting guide allows for a quick check in the field to
help reduce down time. For additional troubleshooting information, refer to
the manuals provided with the other equipment used in the hot melt system.
If you cannot solve a problem with the information given here, contact your
local Nordson representative for help.
Pneumatic Section
The pneumatic section of the transducer consists of three basic parts. See
Figure 3.
A. Pilot section
B. Diaphragm set
C. Inlet
To Next Page
Loading...