9
Before the first use, do the following:
Initial Operation
Do not touch the power cord with wet
hands.
WARNING
(e.g. 110°F)
2. Turn on hot water.
1. The button is ON.
Using the Water Heater
• To prevent scalding :
Hot Water Heater temperatures over 125°F
(52°C) can cause severe burns instantly or
death from scalding.
• Children, disabled and elderly are at the
highest risk of being scalded. Feel water
temperature before bathing or showering.
Temperature limiting valves are available,
consult with installer.
• When setting the Water Heater to 125°F (55°C
in °C mode) or higher, the temperature display
will blink for 10 seconds and emit a tone as a
high temperature warning.
• Take caution when using the Water Heater
again after setting to 125°F (52°C) or higher.
Always check the set temperature before use.
• Do not allow anyone to change the water
temperature while hot water is running.
DANGER
Operation
• The POWER indicator is displayed.
• The previously set hot water supply
temperature is shown.
• The setting temperature displayed may vary
from the actual temperature at the fixture
depending on conditions such as season or
length of piping.
• Turn off hot water, the BURNER ON indicater
disappears.
4. Turn on the power.
1. Open the water supply valve.
CLOSED OPEN
2. Open a hot water fixture/faucet to confirm
that water is available, and then close the
fixture/faucet again.
Hot water
fixture/faucet
3. Open the gas supply valve.
PRIORITY indicator is displayed.
BURNER ON indicator is
displayed during combustion.
Initial Operation / Using the Water Heater
To Next Page
Loading...
