12
(Single Water Heater only)
Flow Meter Alarm
The flow meter alarm is being
used to indicate when a tub is
full.
1. The Power button is ON.
2. Press the MENU button
inside the cover, select
“Flow meter” using the
/ buttons.
4. Change the volume using
the
/ buttons, and then
press the ENTER button.
5. Turn on hot water.
6. Turn off the hot water when
the alarm sounds to prevent
overfilling.
Operation
• Check the current setting
temperature.
• The “
Flow meter” screen
appears.
• To return to the home screen,
press the MENU button or
let it sit for approximately 20
seconds.
• When the tub fills with the
preset volume of water, an
alarm will sound alerting you
to shut off the water.
3. Press the ENTER button.
Customizable Settings
(Default setting = Alarm off)
[For gallon]
10 - 60 gal (In 5 gal intervals),
60 - 100 gal (In 10 gal intervals),
Alarm off
[For liter]
40 - 260 L (In 20 L intervals),
260 - 380 L (In 40 L intervals),
Alarm off
NOTE
• The hot water filling
temperature is
same as the setting
temperature.
• Although the
temperature
can be set to
125°F/50°C or
higher, do not set
the temperature
to 125°F/50°C or
higher as it can
cause severe burns
instantly or death
from scalding.
SHB8126(1)取説RC-9018M.indd 12 2019/08/30 16:41:52
To Next Page
Loading...
Need help?
General