EasyManua.ls Logo

Norrkoping LS520D-7 - Specific Safety Guidelines; Alertness and Appliance Checks; Original Spare Parts and Repairs; Safe Operating Conditions

Norrkoping LS520D-7
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ALWAYS STAY ALERT AND WATCH WHAT YOU ARE DOING.
Use common sense when operating the appliance. Do not use the appliance while you are tired, sick
or under the inuence of alcohol, drugs, medication or other substances that could affect your ability
to react.
CHECK THE APPLIANCE FOR DAMAGES.
If you notice any damages in the appliance, in its guards or other parts, do not use it until it has been
repaired in an authorized service center. Check for alignment of moving parts, free running of moving
parts, breakage of parts, mounting and any other conditions that may affect the appliance operation.
Damaged parts should be properly repaired or replaced by an authorized service center unless ot-
herwise indicated in this instruction manual. Have defective switches replaced by an authorized ser-
vice facility. Do not use the appliance if the switch does not turn it on and off.
USE ONLY ORIGINAL SPARE PARTS AND ACCESSORIES.
The use of any other spare parts or accessories than original parts may cause a risk of personal
injury.
REPAIRS SHOULD ONLY BE CARRIED OUT BY AN AUTHORIZED SERVICE CENTER USING
ONLY ORIGINAL SPARE PARTS, OTHERWISE THIS MAY RESULT IN CONSIDERABLE DANGER
TO THE USER.
SPECIFIC SAFETY INSTRUCTIONS
AVOID DANGEROUS CONDITIONS
Put the log splitter on a 60 - 75cm high, stable, at, and level work bench where there is plenty of
room for handling, and help the operator stay alert. Bolt the log splitter to the work surface if it tends to
slip, walk, or slide.
GUARD AGAINST ELECTRIC SHOCK.
Check that the electric circuit is adequately protected and that it corresponds with the power, volta-
ge and frequency of the motor. Check that there is a ground connection, and a regulation differential
switch upstream. Ground the log splitter. Mark sure your ngers do not touch the plug’s metal prongs
when plugging or unplugging the log splitter. Never open the pushbutton box on the motor. Should this
be necessary, contact a qualied electrician.
INSPECT YOUR LOG
Make sure there are no nails or foreign objects in logs to be split. The ends of the logs must be cut
square. Branches must be cut of ush with the trunk.
DO NOT FORCE THE APPLIANCE.
It will do a better and safer job at its design rate. Never try to split logs larger than those indicated in
the specications table. This could be dangerous and may damage the machine. Don’t use log splitter
for a purpose for which it was not intended.
DO NOT OVERREACH.
Never stand on log splitter. Serious injury could occur if the tool is tipped or if the cutting tool is unin-
tentionally contacted. Do not store anything above or near the log splitter where anyone might stand
on the tool to reach them.