- 5 -
The laminate flooring cutter is equipped
with a sliding extension table (Fig. 7-A)
for supporting longer boards
(41” working length). To adjust, loosen knob
(Fig. 7-B) and extend table to desired length
then tighten knob to lock in place.
Insert material between the cutting blade
and the base, flush with the aluminum
fence; Hold the material with foot then
push handle down to complete a cut.
WARNING! Maintain control of the handle.
Do not allow handle to slam back after
making cut.
ADJUSTING THE TABLE EXTENSION
FIGURE 7
B
A
CUTTING
To Next Page
Loading...