Norstar Doorphone Installation Guide
5
Installation
Step 2: Program Station Ports (cont’d)
2. Perform the following configuration assignments. Refer to the
Norstar Installer Guide for details.
A. Configuration
1.Trunk/Line Data
❏ ensure the Doorphone is not the prime set for any line
2. Line Access
❏ remove all line appearances and line ringing assigned to the Doorphone. If you
do not remove all line appearances, incoming calls will automatically be
answered by the Doorphone.
❏ ensure no answer DNs are assigned to the Doorphone
❏ remove all line pools assigned to the Doorphone
❏ assign only one intercom button to the Doorphone
❏ assign the intercom (I/C) as the Doorphone’s prime line
Note: Two intercom buttons is acceptable, if this is the minimum offered in
**CONFIG programming. Prime line “none” is acceptable if Intercom is not
offered. This is dependent on your system software release.
B. General admin
2. Names
❏ assign a name to each Doorphone (e.g., Front, Gate, etc.)
To Next Page
Loading...