Read carefully the Guide before installing and using the burner
Nortec WB!
Installation and start works have to be carried out only by specialists.
Power supply must be switched off before the works start!
Neglecting safety rules can cause an accident.
NORTEC WB burners use waste engine and transmission oil, kerosene, diesel oil, light fuel oil,
liquid animal and vegetable oil.
The burners combine the functions of fuel supply, heating, spray and air supply, ignition and
flame supervision, so achieving automatic control of the combustion process.
Thanks to their robust and high-quality design NORTEC burners have the following features:
1. Well-automated fuel supply.
NORTEC burners are low pressure burners and compressed air supply with the pressure
from 0.15 to 0.4-0.5 MPa is required for good fuel spray.
2. Optimum mix of air and fuel, stable flame and efficient combustion.
The burners use air swirl technology with a sparger that provides fine and even mix of
sprayed fuel and secondary air, stable, complete and economic combustion.
3. Safe, reliable, automatic control.
NORTEC burners are equipped with an advanced control and safety system from Siemens.
It stops fuel supply and combustion process in case of emergency. Automatic control of fuel
temperature, fuel level in the chamber of preliminary heating, ignition and flame, the system
of automatic shutdown and restart make NORTEC WB burner easy and safe to use.
4. Flexible installation.
Each burner is equipped with long combustion tube and sliding flange that allows to use the
burner with any boiler and heat generator.
5. Easy maintenance.
The burners are easy to dismantle for regular cleaning and service.
To Next Page
Loading...