EasyManua.ls Logo

North Star M157310E.2 - User Manual

North Star M157310E.2
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
M157310E.2
Installation, Operation, and Maintenance Manual
HOT WATER PRESSURE WASHER: Cleans dirty surfaces with high
pressure hot water.
To the Owner:
Thank you for purchasing a NorthStar hot water pressure washer. Your machine is designed for long life,
dependability and the top performance you demand! Take time now to read through this manual so you better
understand the machine’s operation, maintenance and safety precautions. Everyone who operates this machine
must read and understand this manual. The time you take now will prolong your machine’s life and prepare you
for its safe operation. Enjoy the exceptional performance of your NorthStar hot water pressure washer, the
industry leader! The manufacturer reserves the right to make improvements in design and/or changes in
specifications at any time without incurring any obligation to install them on units previously sold.
Quick Facts
Engine Oil Engine is shipped without oil. Fill before starting.
Use SAE 10W-30 motor oil.
Pump Oil Pump is shipped with oil. Remove shipping tape and check pump oil level before
starting. Use SAE 30 Non-detergent pump oil (item # 4043) or Cat Pump Oil (item
#22158) for oil changes.
Water Make sure your water flow is 20% higher than the pressure washer’s flow rate.
Make sure your water is clean and particle free.
Storage Do not allow water to freeze in the pump, hose, coil, or spray gun.
Spraying
Chemicals
Use any NorthStar brand or equivalent pressure washer chemicals.
Adjust soap adjustment knob to regulate cleaning power.
Maintenance
Schedule
Engine: Oil: change after first 20 hours, then annually or every 100 hours.
Spark Plug: clean every 100 hours, replace annually or every 300 hours.
Air Filter: clean every 100 hours, replace annually or every 300 hours.
Pump: Oil: change after first 40 hours, then every 3 months or 500 hours.
Read and understand all manuals before operating.
Any Questions, Comments, Problems, or Parts Orders
Call NorthStar Product Support 1-800-270-0810
Proven Performance
ITEM NUMBER: 157310
SERIAL NUMBER:
Engine Model:
Pump Model:
Flow:
Pressure:
Hose Length:
Lance Length:
Nozzle Size:

Questions and Answers

  • S
    Stephanie MartinezJul 31, 2025
    How to fix North Star M157310E.2 that will not start?
    • U
      urussellJul 31, 2025
      If your North Star Pressure Washer won't start, there are several potential causes. It could be due to the low oil shutdown feature, in which case you should fill the engine with the adequate amount of oil. If the engine is cold, try using the choke to start it. Ensure that there is fuel in the engine and the fuel shutoff valve is open. Check the battery and recharge or replace it if necessary. Lastly, make sure the spark plug wire is securely attached to the spark plug.
  • M
    Michael Myers MDAug 5, 2025
    What to do if North Star M157310E.2 Pressure Washer runs but has no pressure?
    • D
      Daniel LangAug 5, 2025
      If your North Star Pressure Washer runs but isn't producing any pressure, the issue might be a partially clogged or damaged nozzle. Try cleaning or replacing the nozzle. Also, ensure that the water supply provides more than 4 gpm (gallons per minute) of water flow.
  • T
    Tiffany HooperAug 10, 2025
    Why North Star M157310E.2 runs but burner doesn’t fire?
    • J
      Jeremy FoleyAug 10, 2025
      If your North Star Pressure Washer runs but the burner doesn’t ignite, check the following: * Ensure the heat switch is turned ON. * Verify the thermostat is set to the desired temperature and not too low or off. * Confirm the fuel tank is filled with kerosene, diesel, or fuel oil.
  • A
    Andrea TaylorAug 14, 2025
    What causes poor or no detergent supply in North Star M157310E.2 Pressure Washer?
    • J
      Joshua GonzalezAug 15, 2025
      If you're experiencing poor or no detergent supply with your North Star Pressure Washer, consider these possible causes: * The soap control knob might be set too low, so adjust it accordingly. * The detergent container may need refilling, ensuring the chemical strainer is fully submerged. * A high-pressure hose that is too long can also cause issues; try using less hose or moving the machine closer to the work. * The chemical strainer or injector might be clogged; clean them, always start with a clean detergent container, and run clean water through the injector after each use.
  • C
    Cory EstradaAug 20, 2025
    What causes smoke from heat exchanger on North Star M157310E.2 Pressure Washer?
    • B
      brianna28Aug 20, 2025
      If you notice smoke coming from the heat exchanger of your North Star Pressure Washer, it could be due to a couple of reasons. The air band might not be adjusted properly; in this case, adjust the air band until the burner burns cleanly. Another possible cause is poor quality fuel; using kerosene will ensure the cleanest burn.
  • C
    Christopher BuckleyAug 26, 2025
    What to do if North Star Pressure Washer surges or cycles while in bypass?
    • M
      Michael BarrAug 26, 2025
      If your North Star Pressure Washer surges or cycles while in bypass, there are a couple of potential causes. There may be a leak between the unloader and gun; check all connections, tighten any loose components, and replace any damaged ones. Alternatively, the gun may be leaking internally, in which case you should replace the spray gun.

Summary

Important Safety Instructions

General Warnings and Cautions

Key safety warnings and cautions for operating the pressure washer.

Operational Safety Rules

Essential safety rules for operating the pressure washer safely.

Specifications

Installation Instructions

Operating Instructions

Pre-Operation and Water Supply Checks

Essential pre-operation checks and water supply requirements.

Engine Start and Hot Water Operation

Procedures for starting the engine and operating in hot water mode.

Cleaning and Shut-Down Procedures

Guidelines for cleaning surfaces and shutting down the machine safely.

Safety Features

Maintenance Instructions

Troubleshooting Guide

Engine and Burner Issues

Troubleshooting steps for engine starting and burner firing problems.

Electrical Wiring Diagram

Wiring Layout

Burner Wiring

North Star M157310E.2 Specifications

General IconGeneral
BrandNorth Star
ModelM157310E.2
CategoryPressure Washer
LanguageEnglish

Related product manuals