Hazard Signal Word Definitions
Equipment Protection Quick Facts
STOP! Closely inspect to make sure no components are missing or damaged. See the
"Assembly and Initial Set-Up" section for instructions on whom to contact to report
missing or damaged parts.
STOP! Engine is shipped without oil. DO NOT start pressure washer without adding oil
to engine. Please refer to Engine Manual shipped with unit for acceptable grade motor
oils.
Pump is shipped with oil. Remove shipping tape and black vent plug (if present) from
oil fill cap. Check pump oil level before starting.
A battery is not included. The engine will not run and the burner will not fire unless a
battery is installed. Purchase a standard 12VDC, 18 Ah automotive battery (Group 75).
Make sure your supply water flow rate is 20% higher than the pressure washer's flow
rate (see "Specifications" section for detail), and that your water is clean and particle
free.
Do not allow water to freeze in the pump, hose, coil, or spray gun(s).
Use only NorthStar brand or equivalent washer chemicals designed for high-pressure
use. Use soap adjustment knob to regulate cleaning power.
See Engine Owner's manual.
Change oil after first 40 hours, then every 3 months or 500 hours.
Burner fuel filter
/water separator:
Drain water as needed.
Change filter after every 500 hours of use.
Descale coil annually or more frequently as
conditions/performance require.
Inspect coil for soot build-up annually and desoot if needed.
Inspect electrodes annually and clean/adjust as needed
To Next Page
Loading...
Need help?
General
