Troubleshooting
13
Low/Surging pressure or no water flow
See engine manual for oil requirements
B- Engine starting instructions not followed
See engine manual for starting instructions
C- Insufficient water supply
See water supply section of this manual
D- Plugged pump inlet filter
See maintenance section of this manual
Make sure high pressure nozzle is being used
Remove nozzle, check for blockage
Make sure chemical nozzle is being used
J- Back pressure from extra long discharge hose
K- Leak in chemical siphon hose
Replace hose – use hose clamps if necessary
L- Chemical strainer not submerged
Make sure strainer is completely submerged
Specifications
The manufacturer reserves the right to make improvements in design and/or changes in
specifications at any time without incurring any obligation to install them on units previously
sold.