NorthStar 25654 - Initial Set-Up: Inspect and Assemble; Inspect and Unpack Unit; Assembly Instructions

7
Initial Set-Up
Step 1. Inspect & Unpack
Upon receipt, inspect air compressor for missing or
damaged parts. Verify that it is the compressor you
ordered.
See “Component Identification” section of this manual
for a diagram of the compressor and its components.
 For missing components, contact Product
Support at 1-800-270-0810.
 For damaged components, contact the freight
company that delivered the unit and file a claim.
 If complete, fill out product serial number
information. See “Limited Warranty” section of
this manual.
Step 2. Assembly
1. Insert the handle from the grip set into the mounting
structure. Secure using the bolts and washers
(if applicable) from the grip set.
2. Attach the tank wheels to the tank frame using the
tank wheel bolts.
3. Install the rubber pad sets onto the tank feet in the
orientation shown.
Grip Set (Includes)
Handle – Qty 1
Bolt – Qty 2
Model 25653 Only
Grip Set (Includes)
Handle – Qty 1
Bolt – Qty 2
Washer – Qty 2
Model 25654 Only
Tank Wheel Bolt
Qty 2
Model 25653 & 25654
Tank Wheel
Qty 2
Model 25653 & 25654
Nut
Qty 2
Model 25653 only
Rubber Pad Set (Includes)
Rubber Foot – Qty 2
Washer – Qty 2
Bolt – Qty 2
Model 25653 & 25654
Model 25653
Figure 1
Figure 2
Figure 3
Model 25654
Handle
Bolt
Tank
Wheel
Bolt
Wheel
Tank