22
Rudder system
You have already installed the two rail
(see installation steps above)
It remains:
2x Pedals
2x Rolled up bowden wire (1)
1x Rudder blade (2)
1x Pull-up cord (3)
2x Jam cleat (4)
2 Loose ropes (no pic)
Take the rudder blade and insert it on the pickup on the stern. Therefore take off the secure
ring, slide the rudder into the pickup and re-secure it with the ring:
Unroll the two bowden wires. They both
have a little rope and a carabiner at the
end.
(1)
(2)
(3)
(4)
To Next Page
Loading...
