23
Detach the short rope and the carabiner
from the bowden wire.
Lead the short rope from behind through
the bigger hole in the side of the rudder
head.
NOTE: The rope will just squeeze through
the hole. If necessary help along with a
small screw driver or similar.
This has to be done only once!
Now re-attach the carabiner.
Proceed identically on the other side.
The rope and the carabiner always stays
on the rudder.
Now lead the bowden wire from the inside
of the boat (through the loading hatch)
through the small tube at the stern's deck.
Proceed as follows:
First lead the rope through the tube…
To Next Page
Loading...
