ENGLISH
7
Assembly of Base Support
1. Attach Push Handle (C) from inside Storage
Compartment (B) using two #1 Bolts and two
#6 Flat Washers. Attach two #11 Nuts to bottom.
2. Attach Cross Bar (G) to Base Support (F) and secure with
four #1 Bolts and four #6 Flat Washers.
3. Secure Bottom Plate (D) to Base Support (F) using four #1 Bolts and four #6 Flat Washers.
4. Attach Legs (H) to protruding ends of Base Support (F) using two #2
Bolts, two #7 Flat Washers and two #8 Locking Washers.
To Next Page
Loading...
