Vers.1.0 S. 21 / 30
Measurements of the speed systems (publication required by EN 926)
If you use all the available accelerator travel, the A & B risers will get shorter
as follows:
19cm for the PRION 25 & 27
16cm for the PRION 21 & 23
14cm for the PRION 19
The C riser reduces its length by exactly half of the value of the A&B riser. The
D riser remains the same length.
Service and maintenance
General advice
To keep your glider in good condition for many years, please consider the
following advice:
Don’t expose your glider to unnecessary UV radiation – for example
by leaving it on the landing site unpacked.
Don’t fold the Mylar reinforcements at the cell openings too hard.
If you pack the glider when it is wet or just damp, it has to be dried
later. Don’t leave it packed in a wet condition!
When you practice ground handling, avoid crashing the glider hard on
the ground with the leading edge, as this might lead to damage.
Avoid unnecessary dirt or sharp stones touching the lines and the
cloth. Don’t step on the lines if they are laying on a stony surface!
Humidity combined with dirt can lead to shrinking of the lines and
thereby to the wrong trim on your glider. Saltwater (sweat) may
damage the lines in the long run.
To store your glider for a longer time, avoid a humid or a very hot
environment. (Like in a car during hot summer days)
To Next Page
Loading...
Need help?
General
