Need help?Do you have a question about the NOVAK 610-RV and is the answer not in the manual?
Warning against operating the device in or around water.
Properly position and attach heat sinks to transistors for optimal performance.
Solder capacitors between motor brush tabs and ground tab to reduce radio noise.
Connect speed control wires to battery and motor, using recommended connectors or hard wiring.
Setting transmitter throttle adjustments (ATV, EPA, ATL, EXP, SUB TRIM, TH TRIM).
Adjust Neutral, High Speed, and Brake pots for proper LED indication.
Sets the maximum current to the motor to prevent wheel spin and overheating.
Addresses issues from incorrect receiver placement, bad connections, or wire routing.
Causes and solutions for speed control overheating, including motor gearing and cooling.
Troubleshooting faded or unpredictable brakes due to setup or overheating.
General| Brand | NOVAK |
|---|---|
| Model | 610-RV |
| Category | Controller |
| Language | English |
To Next Page