Need help?Do you have a question about the NOVAK HAMMER PRO ESC and is the answer not in the manual?
Highlights the simplicity, high frequency operation, and new features of Novak Hammer Pro and Racer ESCs.
Critical warnings covering water exposure, cell count limits, wiring, heat sinks, and power disconnection.
Guidance on preventing radio interference caused by motor capacitors, receiver placement, and antenna.
Explanation of CLC II for preventing amp draw, overheating, and for traction control adjustments.
Connect the ESC wires to the motor, ensuring proper capacitor and diode installation.
Properly install large and small heat sinks onto ESC transistors for cooling.
Instructions for mounting the ESC for airflow and the receiver away from interference sources.
Plug ESC into Channel 2 and servo into Channel 1 of the receiver.
Ensure the transmitter is turned on before powering the ESC.
Step-by-step process to set ESC throttle endpoints and brake settings.
Guide to changing the ESC input plug for compatibility with different radio systems.
Detailed steps for installing motor capacitors, Schottky diode, and wiring connections.
Recommended basic transmitter settings for proper ESC operation.
Detailed procedure for setting the ESC throttle range via the One-Touch Set-Up.
Addresses issues like programming failures, no throttle response, glitches, and slow acceleration.
Guidelines for sending ESCs for service, warranty claims, and customer support contact.
General| Brand | NOVAK |
|---|---|
| Model | HAMMER PRO ESC |
| Category | Controller |
| Language | English |
To Next Page