Need help?Do you have a question about the NOVAK DUSTER II SPORT and is the answer not in the manual?
Details on included accessories like brake light kit, motor capacitors, and cooling fan.
Kit to power two brake light LEDs, mounts on chassis or body.
Required to prevent radio interference, three 0.1µF capacitors needed per motor.
Optional fan for extra cooling for heavy load applications.
System to convert signal harness for compatibility with major radio systems.
Do not operate model in or around water; keep ESC dry.
Use only 4 to 10 sub-C cells (1.2 volts/cell) in the main battery pack.
Three 0.1µF (50V) ceramic capacitors must be installed on every motor.
Prevent transistor tabs or heat sinks from touching each other or metal.
Always disconnect the battery pack from the speed control when not in use.
Always turn on the transmitter power before turning on the speed control.
Be careful, transistor tabs can get hot and cause burns.
Always insulate exposed wiring with heat shrink tubing to prevent shorts.
Motors generate noise; install three 0.1µF (50V) capacitors on motor.
Mount receiver/antenna away from noise sources like motor and battery.
Worn brushes cause noise; replace or clean motor brushes and commutator.
Place one heat sink onto the left bank of 3 transistor tabs.
Press the second heat sink onto the right bank of 3 transistor tabs.
Do not force heat sinks; ensure a snug fit and prevent short circuits.
Position ESC away from receiver/antenna for optimal radio performance.
Mount ESC using double-sided tape for isolation from shock and vibrations.
Mount the ON/OFF switch in an easily accessible location.
Mount receiver as far as possible from ESC, motor, and battery to minimize noise.
Mount antenna close to receiver; trail excess wire off the top, do not cut.
General| Brand | NOVAK |
|---|---|
| Model | DUSTER II SPORT |
| Category | Controller |
| Language | English |
To Next Page