Novamatic TK 660 E - Adjusting the Level of Conductivity; To Access Adjustment Mode; Memorizing the New Setting

25
Water contains, a
variable quantity of
limestone and
mineral salts of
which quantities
vary according to
geographical
locations thus
varying its
conductivity values.
Relevant variations
of the conductivity
of the water
compared to those
prefixed by the
factory could slightly
influence the
residual humidity of
the laundry at the
end of the cycle.
Your dryer allows
you to regulate the
sensitivity of the
drying sensor based
on conductivity
values of the water
by using the
following procedure.
To access
adjustment
mode:
Turn the
programme selector
dial to switch on the
appliance. In
selection mode,
press
simultaneously the
buttons 3 and 5.
Press the buttons
down until the pilot
lights above each
ones begin to flash
and one of the pilot
lights indicating the
drying phase lights:
W ä rmetausher ,
Siebe,
B e h
ä lter
remains lit.
Adjusting the
level of
conductivity:
Press the
Start/Pause (5)
button sequentially:
the level of
conductivity is
indicated by the
phase pilot lights,
which light in
various
combinations as
follows:
Normally, the
appliance is
factory-set to the
highest level;
however, certain
models may be
configured
differently.
Memorizing the
new setting:
Simultaneously
press down the
buttons 3 and 5 until
the previous drying
cycle time appears
again on the display
and the buzzer
sounds.
Adjusting the level of conductivity
Display Conductivity degree Approximative value (µS/cm)
B e h ä lter Low < 300
Sieb Medium 300 - 600
W ä rmetausher High > 600
1
2
3
4
5
1
2
3
4
5