Novamatic TK 660 E - Indicator Lights; Start;Pause Button Operation; Delayed Start Function

29
button the
acoustic signal is
switched off.
The corresponding
light comes on.
6 Indicator lights
These lights
indicate the
following functions
:
• “Trocknen” -
drying light
This light
indicates that the
appliance is in the
drying phase.
• “Ende” - end of
programme light
This light is on at
the end of the
cooling phase,
during the anti-
creasing phase and
at the end of the
programme.
“Wärmetauscher”
light
(Clogged
condenser)
It comes on every
80 cycles to remind
you that the
condenser must be
cleaned.
“Siebe” light
(Clogged filters)
This light
illuminates at the
end of the
programme to
remind you that the
filters must be
cleaned.
Bhälter light
(Full tank)
This light comes on
at the end of the
programme to
remind you that the
water reservoir
must be emptied
out. If this light
illuminates during a
programme this
means that the
water reservoir is
full. The buzzer
sounds, the
programme stops,
the light of the Start
/ Pause
button flashes.
7 Start/pause
button
Press this button to
start the dryer after
having s elected the
programme and the
options.
The relevant light
will stop flashing. If
you have chosen a
delayed start, the
machine will begin
the countdo wn.
If the door of the
appliance or the
small door at the
bottom is opened
while the
programme is
running, this
button must be
pressed again
after closing the
door in order to
restart the
programme from
the point at which
it was interrupted.
This button must
also be depressed
after a power
failure and after
having re-inserted
the water
reservoir, if it has
been emptied in
the middle of a
programme after
lighting up of the
“Siebe” light.
In both cases the
light of the”Start
/Pause”
button flashes to
remind you that the
start button needs
to be pressed
again.
8 ZEITVORWAHL-
delay Start button
This button allows
you to delay the
starting of the
programme by 3, 6
or 9 hours.
Press the button
until the light
relevant to the
desired delay lights
up. This option
must be selected
after having
selected the
programme and
before 3 6 9
pressing”Start
/Pause” to start
the programme.
The machine
begins the
countdown, which is
shown by the pilot
lights. For example,
if you have chosen
a 9- hour delay
(pilot light 9h lit),
after 3 hours, 9h
goes out and 6h
lights up; after 3
more hours, 6h
goes out and 3h
lights up. When the
9 hours are over
(pilot light 3h off),
the drying cycle
begins. During the
delayed start
period, it is not
possible to change
the programme or
the selected delay.
If you wish to do so,
you must first
cancel everything
by rotating the
programme selector
dial to position
“Aus”
Select the new
programme, the
options and the
delayed start, then
press “Start /Pause
If you wish to
change only the
options, this can be
done on condition
that the new
option(s) is(are)
compatible with the
programme. Set the