Novamatic TK 660 E - Operating Sequence; Drying Process; After Each Use

To Next Page

To Previous Page

Operating sequencee

Before using your tumble dryer for the first time, we recommend to place a few

dampclothsinside the appliance and dry for 30 minutes.

There may be dust inside a brand new tumble dryer.

Drying

1. Connect the

appliance.

2. Open the door

(see picture).

3. Load the items

one at a time,

shaking them

out loosely.

4. Close the door.

Please check

the laundry does

not get caught

between the

door and filter.

5. Select the drying

programme or

time. The lights

Trocknen and

Ende come on.

The light of the

Start/Pause

button flashes

and the display

shows the

duration of the

programme.

6. If required, press

the Schonen

button

and/or the

Signal

button.

7. Select the

Zeitvorwahl if

required. The

selected delay

appears on the

display for 2

seconds, then

the duration of

the selected

programme is

displayed.

8. Press

theStart/Pause

button: the

corresponding

light stops

flashing and

drying starts.

Only the

Trocknen light

stays lit. If you

have selected

the

, the machine

begins its

countdown.

The drum turns

alternately in

both directions

during drying.

All drying

programmes

end with a 10

minute cooling

phase.

You may remove

the laundry after

this phase.

The Ende,Siebe

and

lter

lights illuminate

and the buzzer

sounds

The display shows

a static zero.

9. If the laundry is

not removed at

the end of the

cycle, the dryer

performs an

anti-creasing

phase (duration:

30 minutes

maximum).

If you do not

remove the

laundry, the

dryer will stop

automatically at

the end of the

anti-creasing

phase.

The Ende,Siebe

and

lter

lights

remain lit and

the buzzer

sounds every 10

seconds for 2

minutes.

The light of the

Start/Pause

button goes

off and a

flashing zero

appears on the

display.

10. Turn the

programme

selector dial to

“Aus” ; all the

lights go out.

The appliance is

switched off.

Remove the

laundry.

If you open and

then close the

door before

turning the

programme

selector dial to

“Aus” , all the

lights

corresponding

to the phases

making up the

performed

programme

come on and

the display

shows the

duration of the

programme.

After each use

• Clean the filters .

• Empty the water

reservoir

P1149

P1108

Novamatic TK 660 E - Operating Sequence; Drying Process; After Each Use

Table of Contents