Novar ED&S Response PL4 User Manual

PREMIUM WIRED ALARM SYSTEM (PL4)
Contents
Section 1 – Overview of System
1.1 Safety statement
1.2 Kit Contents
1.3 Tools Required
1.4 System Features
Section 2 – Planning your Installation
2.1 Location of components
2.2 Planning the location for the system components
Section 3 – Installing the System
3.1 Control Unit
3.2 Movement Detector/PIR
3.3 Door/Window Contact Detector
3.4 External Siren & Strobe
3.5 Testing the System
Section 4 – Using the System
4.1 User PIN
4.2 Changing the User PIN
4.3 Set / Clear chime Zones
4.4 Set / Clear Home-Bypass Zones
4.5 Set / Clear bypass Zones
4.6 Display bypass Zones
4.7 Display Zones with faulty devices
4.8 Display Home-Bypass Zones
4.9 Set delay time
4.10 Set siren & strobe duration time
4.11 Walk Test command
4.12 Clear the Alarm Hold Indications
4.13 Panic alarm
4.14 Silencing the System
4.15 Arm (set) the Alarm System while Exiting the House
4.16 Disarm (unset) the Alarm System while Entering the House
4.17 Arm (set) the Alarm System when you are Inside the House
4.18 Summary of the zones in different mode
4.19 Summary of Factory Settings
4.20 Status LED indications
Section 5 – Maintenance
Section 6 – Extending the System
Section 7 – Troubleshooting
Section 8 – Specifications
APPENDIX

Novar ED&S Response PL4 Specifications

General

Brand	Novar ED&S
Model	Response PL4
Category	Security System
Language	English

Summary

Overview of System

Safety

Safety warnings before installation, including electrical hazards and protective measures.

System Features

Highlights key features of the Premium Wired Alarm System, including zone capabilities and technology.

Planning Your Installation

Location of components

Installing the System

Movement Detector/PIR

Instructions for removing, mounting, and configuring the PIR detector.

Door/Window Contact Detector

Guidance on selecting locations and mounting the magnetic contact switch and magnet.

Testing the System

Procedures for testing detectors and the external siren/strobe after installation.

Using the System

User PIN

Explains the function of User PINs for disarming and changing modes, noting factory defaults.

Changing the User PIN

Step-by-step guide on how to change the existing User PINs for the system.

Set /Clear Home-Bypass Zones

Set / Clear Bypass Zones

Display Zones with faulty devices

Set delay time

Set siren & strobe duration

Walk Test command

How to enable and exit the walk test mode for system testing.

Panic alarm

Silencing the System

Arm (set) the Alarm System while Exiting the House

How to arm the system when leaving the premises, using the "OUT" mode.

Disarm (unset) the Alarm System while Entering the House

Procedure to disarm the system upon entering the premises using the User PIN.

Arm (set) the Alarm System when you are Inside the House

How to arm the system for protection while inside the house, using the "HOME" mode.

Summary of Factory Settings

Status LED indications

Troubleshooting

Control Unit

Lists common issues with the Control Unit and their possible causes and cures.

PIR Detector

Lists common issues with PIR detectors and their possible causes and cures.

Magnetic Contact Detector

External Siren & Strobe

Lists common issues with the external siren and strobe and their possible causes and cures.

Specifications

Control Unit

PIR

Door/Window Contact Detector

External Siren & Strobe Unit