To Next PageTo Next PageWhat to do if my NovaTec Dryer unit is not running?
If your NovaTec Dryer unit isn't running, the control main circuit breaker might have tripped, the main power could be off, or the control power might be interrupted. Try resetting the breaker. Also, check the line and main power supply, and inspect each item according to the electrical wiring diagram.
Why is the material in my NovaTec NovaWheel NW hopper not getting dried properly?
If the material in your NovaTec Dryer hopper isn't drying properly, it could be due to several reasons. The door gasket might be leaking or damaged, there could be a leak in the hose, or the hose connection might be loose. Also, the process temperature might be incorrect for the material being dried, or the hopper might be running almost empty. Check all gaskets (filter cover, hopper doors, and hopper lids) and repair or replace any damaged gaskets. Replace the hose and tighten hose connections. Add material to the hopper to maintain a higher level.
Details where to place the dryer for optimal operation and maintenance.
Guidelines for connecting process air piping to the dryer.
Instructions for safe and compliant electrical hookup of the dryer.
Information on connecting the cooling water supply for the dryer's cooling coil.
Explains how the process outlet temperature is managed by the controller.
Details the control of reactivation temperature, a critical drying parameter.
Explains how to interact with the touch screen interface, enter values, and use the keyboard.
Provides a guide to the various screens, menus, and operational functions of the NovaTouch system.
General
