Why is the OVER TEMP light on in my NovaTec NovaDrier ND-50 Dryer?
If the OVER TEMP light is on in your NovaTec Dryer, it's often due to incorrect deviation or alarm set points in the temperature controller(s). To fix this, adjust the settings for your specific drying application. It could also be due to thermocouple failure(s), in which case you should repair or replace the thermocouple(s).
What to do if the LOW AIR PRESSURE light is on in my NovaTec NovaDrier ND-50 Dryer?
If the LOW AIR PRESSURE light is on for your NovaTec Dryer, make sure the air LOWER valve is fully on (handle is vertical) and that ample air is supplied (85 psi +) as indicated on the pressure gauge on the side of the cabinet. Also, drain any water and clean the drainage tubes and/or base of the filters. Consider replacing both filters.
Critical information regarding compressed air requirements, including a warning about ozone damaging the membrane.
Specific requirements for compressed air quality, pressure, temperature, and the critical warning about ozone.
Procedure for connecting the compressed air line, detailing required pressure, temperature, and line size specifications.
Steps to power on the NovaDrier, ensuring correct air pressure and hopper fill level before activation.
Procedure to adjust both the upper and lower heater temperature set points for optimal drying performance.
A detailed chart listing common problems, conditions, codes, checks, and solutions for effective troubleshooting.
To Next Page
General
