Why is the OVER TEMP light on in my NovaTec NovaDrier ND-100?
If the OVER TEMP light is on in your NovaTec Dryer, it's often due to incorrect deviation or alarm set points in the temperature controller(s). To fix this, adjust the settings for your specific drying application. It could also be due to thermocouple failure(s), in which case you should repair or replace the thermocouple(s).
What to do if the LOW AIR PRESSURE light is on in my NovaTec Dryer?
If the LOW AIR PRESSURE light is on for your NovaTec Dryer, make sure the air LOWER valve is fully on (handle is vertical) and that ample air is supplied (85 psi +) as indicated on the pressure gauge on the side of the cabinet. Also, drain any water and clean the drainage tubes and/or base of the filters. Consider replacing both filters.
Lists standard set points for air amplifier, pressure switches, temperature controllers, and sensors.
Instructions for mounting the NovaDrier to a processing machine using the supplied control panel support bracket.
Connect electrical power through a main line disconnect and ensure a true earth ground connection.
Explains causes and solutions for 'OVER TEMP' and 'LOW AIR PRESSURE' fault lights.
Provides a detailed chart linking problems to codes, conditions, and solutions for various issues.
To Next Page
General