1. If engine does not speed up after several seconds , briefly turn
CHOKE LEVER to ‘CLOSED’ position.
.
3. Choke can typically be opened and some load applied at less than 1
minute after start-up, slightly longer if ambient temperatures are cold. If
opened or too large a load applied too early, engine operation can
become unsteady. Yellow light on User Interface indicates system
"warm-up" mode during start-up. When yellow light is no longer
illuminated, engine is fully warmed up and full load can be applied.
2. Allow engine to warm up for 20 seconds to 1 minute then turn
the CHOKE LEVER to the ‘OPEN’ position.
STARTING ENGINE (cont’d)
To Next Page
Loading...