8
CUBASE
To set up the Impulse as a HUI control surface in Cubase, navigate to ‘Studio’ > ‘Studio Setup’ > ‘MIDI Port
Setup’. Be careful to set your ports as shown below, the ‘Impulse HUI’ port MUST NOT have “in ‘all MIDI
ins’” enabled.
Click the small ‘+’ icon in the Cubase ‘Studio Setup’ window and select ‘Mackie HUI’. Now, in the ‘Mackie
HUI’ tab, set the input and output port to ‘Impulse HUI’ as shown below.
Note: the ‘Impulse HUI’ port may show as ‘MIDIIN3’/’MIDIOUT2’ or similar on Windows.
To Next Page
Loading...
