9
REAPER
Please note that Reaper version 5.941 or newer is required to work with the Impulse.
To set up the Impulse as a HUI control surface in Reaper, navigate to ‘Options’ > ‘Preferences...’ > ‘MIDI
Devices’. Be sure to set your ports to ‘Focusrite A.E. Ltd. - Impulse HUI (MIDIIN3 for Windows), as shown
below, the ‘Focusrite A.E. Ltd. - Impulse HUI’ should not say ‘!! N/A...’ If this is the case please right-click the
device and choose ‘Forget device’.
Navigate to the ‘Control/OSC/web’ tab in the ‘Reaper Preferences’ window and click ‘Add’ to add a new
control surface. Now, in the ‘Control Surface Settings’ window, set the Control surface mode to HUI
(partial) and set the input and output port to ‘Focusrite A.E. Ltd. - Impulse HUI’ as shown below.
To Next Page
Loading...
