Novitek LUMISPA 603 - User Manual

Questions and Answers

V
vmartinezAug 7, 2025
Why is the water in my Novitek LUMISPA 603 cloudy?
- J
  jonathanhortonAug 7, 2025
  Cloudy water in your Novitek Hot Tub can occur due to several reasons. It might be caused by a dirty filter, so cleaning the filter is advisable. Another reason could be that the pH value is not within the recommended range, and you should adjust the water pH level. Insufficient use of cleaning chemicals or using the same water for too long can also cause this issue. In the latter case, replace the water in the pool.
K
Kelly LoweAug 11, 2025
What to do if my Novitek LUMISPA 603 Hot Tub water smells like chlorine?
- D
  Darren CohenAug 11, 2025
  If your Novitek Hot Tub water smells strongly of chlorine, it could be due to a chlorine level that is too high; in this case, you should wait for the chlorine level to decrease. Also, a water pH level that is too low might be the reason, so you should adjust the water pH level to the recommended range.
A
Andres EllisonAug 16, 2025
What to do if my skin is irritated after using my Novitek Hot Tub?
- C
  Cody WilsonAug 16, 2025
  Skin irritation after using your Novitek Hot Tub may be due to unhygienic water. Try adding a cleaning chemical to the water. It could also be caused by free chlorine levels being over 5 mg/l; in this case, you should wait for the free chlorine levels to drop.
K
Katherine BrownAug 20, 2025
How to get rid of algae growth in my Novitek LUMISPA 603?
- J
  Jennifer WellsAug 20, 2025
  Algae growth in your Novitek Hot Tub can occur if the water pH level is too high, so you should adjust the water pH level to the recommended range. Also, you may need to add a cleaning chemical to the water.
J
Jacob MyersAug 25, 2025
How to get rid of musty smell in Novitek LUMISPA 603?
- T
  Theodore GambleAug 25, 2025
  If your Novitek Hot Tub has a musty smell, it's likely due to bacterial or algae growth. To resolve this, you should empty, clean, and refill the pool.
O
orushAug 28, 2025
How to remove organic layer from Novitek LUMISPA 603 Hot Tub?
- D
  dcarlsonAug 28, 2025
  If you notice an organic layer in your Novitek Hot Tub, it's likely due to accumulated oil and dirt. You can wipe the dirt away with a clean sponge.
M
Mark WhiteSep 1, 2025
What causes patches on the surface of my Novitek Hot Tub?
- S
  scottgomezSep 1, 2025
  Patches on the surface of your Novitek Hot Tub can be caused by too much calcium in the water, so you should adjust the water pH level to the recommended range. The total alkalinity of water may also be too low.