Novitool Aero 325 - Page 8

www.flexco.com
—8—
General Safety Rules – Save These Instructions
Do not wear loose clothing or jewelry. Keep
your hair, clothing, and gloves away from
moving parts. Loose clothes, jewelry, or long
hair can be caught in moving parts.
When moving in transport case, ensure casters
are unlocked and case is latched securely.
Abide by all instructions and warning labels.
is equipment is not to be used by children
or persons with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge of the equipment.
4. USE AND CARE
!
WARNING
Read and understand Aero® operations manual
before using machine.
Do not store solvents in Aero® transport case.
!
CAUTION
Only operate Aero® with machine positioned on
a level, rm surface.
NEVER use a machine which is defective or
operating abnormally. If machine appears to
be operating unusually, making strange noises,
or otherwise appears defective, stop using it
immediately and arrange for repairs.
Do not use machine if switch does not turn
it on or o. Any machine that cannot be
controlled with a switch is dangerous and must
be repaired.
Never alter or remove safety devices.
Operating press with extension cord will cause a
voltage drop.
Operating a press with a generator may
compromise the press operation and product
reliability.
!
CAUTION
In the event of static discharge to the Aero
325 press during splice process, the press may
enter a safety mode status. e display panel
will advise "Warning 1 of 1". e cooling fans
will turn on to lower the temperature. Aer
the press has cooled, release the pressure by
pressing the blue button. Turn the press "o".
Check the splice quality. If splice needs further
cooking, turn press "on" and the warning alert
will have cleared.
!
WARNING
Operating press on incorrect voltage can cause
serious damage and potential hazards. Available
Aero® power cords:
• 110 volt; single phase
• 230 volt; single phase
• 230 volt; three phase
• 400 volt; three phase + neutral
• 400 volt; three phase
• 460 volt; three phase
Do not use outdoors. is machine is designed
for indoor use only. e press must be
transported in transport case when outdoors.
Inspect machine before each use. Ensure
machine and power cable are not damaged.
Machine shall not be operated with damaged
controllers, power cords, or other mechanical
components.
Avoid dropping or severe handling of machine
at all times, including during movement in
transport case.
If the electrical supply cord is damaged, it must
be replaced by a special cord available from the
manufacturer or it’s service agent.
3. PERSONAL SAFETY
!
WARNING
Use safety equipment. Always wear eye
protection, gloves, non-skid safety shoes, and
adhere to other safety standards of the facility
where operating the press.
Stay alert, watch what you are doing, and use
common sense when operating a machine. Do
not use machine while tired or under inuence
of drugs, alcohol, or medication. A moment of
inattention while operating machines may result
in serious personal injury.