Novitool Aero 325 - Press Lifting and Rigging Guidelines

—9—
General Safety Rules – Save These Instructions
!
CAUTION
e Aero has been optimized for process speed,
portability, and ease of use. A resulting aect
of the designed portability is that the structure
will deect as internal air pressure is increasing
during splice process. e length of press will
determine how much deection will occur at
any specic pressure. Beam extrusions were
designed with strength to return to their normal
state when pressure is relieved; deection will
not be permanent.
Press Lifting and Rigging Guidelines
e following guidelines should be used to li an Aero press when using equipment to assist:
1. Determine the approximate center of gravity for liing safety before liing the press.
2. Always test-li the press to determine the exact unit balance and stability before hoisting it to full height.
3. Ensure that all liing equipment is operated by qualied personnel.
4. Ensure the rigging equipment and material have the required capacity for the job and that all items are in
good condition.
5. ese instructions are recommendations only as other congurations may be more suitable than shown
based on rigging equipment used.
6. e upper beam fan inlet holes may be used as liing locations with straps. Attach two straps through the
two furthest outside vent holes in the upper extrusion. Ensure the bottom beam connector bolts are secured.
Check for misalignment or binding of moving
parts, breakage of parts, and any other condition
that may aect machine operation. If damaged,
have machine serviced before using.
In order to maintain air ow, do not cover the
air inlets on top, at ends and on sides where air
ows through.
Maintain machine in clean condition. Remove
any oils, greases, or food product from outside
and inside machine.