Do you have a question about the NOVOFLEX MagicBall MB MINI and is the answer not in the manual?
Brand | NOVOFLEX |
---|---|
Model | MagicBall MB MINI |
Category | Camera Accessories |
Language | English |
Mount the MagicBall® on any tripod using its 1/4” or 3/8” thread after removing the stepping insert.
Mount the camera by using the 1/4” screw and tighten counter-clockwise. Loosen by turning clockwise.
Lock positions with the locking grip. Use the friction control knob to adjust head movement for safe operation.
Release the locking grip only when the mounted equipment is held at the same time to prevent sudden overturning.
The MagicBall® can carry its maximum load firmly in any position, with specific capacities for MB MINI, MB 50, and MB models.
For heavy equipment, tighten the knurled ring fully, then turn the device opposite until it stops for a strong connection.
The knurled ring has a 1/4” screw. A 3/8” thread requires an over-thread or factory conversion.
Adjust friction control knob based on camera weight; heavier equipment requires more tightening.
The ball works lubricant-free; avoid oil or grease. Keep the ball clean from sand and dust with a dry cloth.
The MB (large model) locking grip can use a supplied rubber sleeve for a more comfortable grip.
Loosen the knurled ring, turn the camera 90°, and retighten to change from landscape to portrait mode.
Use a panorama base like the NOVOFLEX PANORAMA II for landscape/portrait changes, leveling, and angle targeting.
Replace the standard locking grip with the MB-GRIFF for easier handling and smoother panning with long telephoto lenses.