Novomatics Operation Manual AlphaTackPlus
34
There are minor mechanical tolerances from piston to piston. These tolerances can cause
that the new piston is either too high or to low at top position. That’s why the top position has
to be re-tuned.
Feel with you finger tip whether the piston
is to high, to low or in exact position.
Use the dialog Instrument\Ink Dispenser settings… for returning the top position
Figure 18
Release the dialog with ok, when you feel a smallest or no edge. Please note your finger tips
are very sensitive, usually you can feel edges down to 10 microns.
To Next Page
Loading...