Need help?Do you have a question about the Nowy Styl eModel 2.0 and is the answer not in the manual?
General| Brand | Nowy Styl |
|---|---|
| Model | eModel 2.0 |
| Category | Indoor Furnishing |
| Language | English |
Steps for initialising a workstation with a display control panel.
Steps for initialising a workstation without a display control panel.
Steps to reset malfunctions on a workstation with a display control panel.
Steps to reset malfunctions on a workstation without a display control panel.
Imminent threat to life and health, severe injuries, or material damage.
Warning about 100-240 V AC and potential electric shock from moisture.
Information on safe use to avoid crushing hazards.
General notes providing information regarding safe use of the eModel 2.0.
Guidelines for correct usage, safety distance, load, and user age.
Safety precautions during transport, including risk of crushing.
Illustrates electrical connections and lists key components.
Safety considerations during installation and general use of the workstation.
Instructions and safety warnings for the sliding top lock mechanism.
Advice on noise levels, overload risks, and managing loose cables.
Advice on adjusting chair, armrests, and changing positions for ergonomics.
User caution and responsibility, warnings for children and body parts.
Procedure to ensure correct operation by initialising the workstation base.
Instructions for decreasing and increasing desk height using the control panel.
Steps to reset the workstation by holding down specific buttons.
Procedure to ensure correct operation for panels with display and memory.
Instructions for decreasing and increasing desk height using the control panel.
Steps to save a desired desk height to memory positions.
How to switch between centimetres and inches for height display.
Procedure to correct discrepancies between displayed and actual desk height.
Steps to restore all settings to their original factory default values.
Configuring the lowest possible stop position for the desk.
Steps to remove previously set minimum or maximum height limits.
Common causes and solutions when the workstation fails to move.
Troubleshooting steps for a workstation that only moves slowly downwards.
Solutions for a workstation that moves slowly in general.
Causes and solutions for limited movement in a single direction.
Covers short circuits, disconnected cables, and relay issues.
Addresses system protection, collision detection, and overload errors.
Explains loss of synchronisation and anti-collision sensor errors.
Covers sticky buttons, low/high voltage, and parameter discrepancies.
Relates to reference movement, sensor calibration, and restart requirements.
Indicates normal operation when power is first supplied.
Signal for a reset/initialization procedure after a previous action.
Error indicating a lost connection with a drive, preventing movement.
Confirmation of saving or deleting height limit positions.
Error due to drives not having the same height, requiring recalibration.
Details on voltage, energy consumption, and rated power.
Specifies ambient conditions, load limits, and continuous operation time.
Includes adjustment range, noise emissions, lifting speed, and anti-collision.
States manufacturer details, product name, model, and version.
Lists directives and harmonised standards the product conforms to.
Identifies the person authorised to compile technical documentation.
Emphasises that only qualified personnel should perform maintenance.
Safety warnings for cleaning, especially regarding electrical shock.
Instructions for proper disposal of desk components according to regulations.
To Next Page
