Pág. 16
English
We can congure the following parameters:
• CLIP T: It is the time we want the clip resulting from the time lapse to last.
• CLIP FPS: The speed, in frames per second, at which we will compile the video clip. It is used to
calculate the number of shots to take.
• INTERVAL: The time between shots. You will be limited by the minimum time required to travel be-
tween shots, and the exposure time.
• EXP TIME: Exposure time. Selecting it will access to another menu where is possible to dene and
control the exposure time in various ways.
EXP MODE:
<1s: The default mode is the one where an exposure time controlled by the camera
and less than 1 second will be used.
> 1s: It is used to determine exposure times greater than one second. Is possible to
use exposures controlled by the camera itself or give control of the exposure to the
slider.
For the slider to control the exposure, the camera must be set to Bulb (B) mode, and
select “YES” in the BULB CTRL box on the remote’s menu.
RAMP: It allows dening an exposure ramp controlled by the device. The parameters that will
dene this exposure ramp are:
INITIAL EXP: The initial exposure time, which will remain constant until the start of
the ramp
START: Starting moment of the ramp, it will be dened in terms of time lapse time.
That is, if the rest of the parameters dened is a time lapse of 2 hours, this parame
ter can be varied between the instant 0h 0m and 2h 0m
FINAL EXP: The nal exposure time, which will remain constant from the end of the
ramp to the end of the time lapse
FINISH: The moment of the ramp’s end, will be dened in terms of time of time of
time. It can take values from START to the total duration of the time lapse.
• RAMP: Allows to dene a spatial ramp, making the displacement between the initial and nal photos
shorter than the displacement between the photos in the central section. This variation of scrolling runs
in a fully controlled and progressive manner, and will have a soft start and stop eect on time lapse
once compiled.
• PREVIEW / GO: Appear once a movement has been recorded. It allows to make a preview (PRE-
VIEW) where the movement is executed continuously, or to start the the time lapse’s sequence (GO).
To Next Page
Loading...
Need help?
General
