Pág. 14
English
Using the controller:
1. To scroll through the menu, turn the control knob.
2. Short press on the control wheel: select / enter / activate / execute.
3. Long press on the control wheel: perform the exit / return / end / power o action.
Manual mode: Allows you to control the movement in real time.
• Turning the knob will cause the speed to increase or decrease in one of the two directions of rotation.
• One press of the knob will cause direct passage to speed 0.
• A quick double press will change the control to another axis of rotation (as long as there is some other
axis of rotation enabled from the main menu).
NOTE: In manual mode, we can only move a single axis simultaneously. A loss of connection between
the control and the appliance will also cause a safety braking.
Auto mode: Allows you to program a tour and play it whenever you want with dierent acceleration
and speed parameters.
Single-section automatic movement
• Press the knob by placing the cursor in the box with the pictogram of the movement sections.
• Move the dierent axes and set the start and end points by pressing the knob on the knob.
• A quick double press will take us back in the recording sequence, allowing previously set points to be
changed.
• Once established all the necessary points, keeping the knob pressed will nish the programming and
the device will take all the axes to the initial point that has been established.
• Once the points have been recorded, we can dene the speed (SPEED1) and acceleration (RAMP)
parameters.
SPEED1: Denes the speed on a scale from 1 to 40. It is possible that the system limits the
speed selection due to the fact that the available distance is not enough to reach the highest speeds.
RAMP: Denes the percentage of the travel that will be used to accelerate and decelerate.
Accelerations will always have a symmetrical prole, that is, the same distance will be reserved for
accelerating as for braking.
REPEAT: We can choose between a repetitive movement that reproduces the programmed
section successively forward and backward. One press of the knob will stop the movement and return
the appliance to the initial position.
GO: A press with the cursor on GO starts the movement sequence.
Slider Control
Travelling
Tilting
Panning
To Next Page
Loading...
Need help?
General
