Installation procedures
4
ALL PICTURES SHOWN ARE FOR ILLUSTRATION PURPOSES ONLY. THE ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENT.
Step 3 - Remove the clevis pin, nut, washer, and spring washer, from the bolt, and
remove the bolt and rubber pulley from the down rod. Place rubber pulley
onto ceiling fan hook, insert flap to rubber pulley, and align holes. Push the
bolt from one side of the flap through the rubber pulley to the other side of
the flap. Place washer, and spring washer through the bolt, tighten the nut,
and push the clevis pin into the hole found on the threaded end of the bolt.
To Next Page
Loading...