To Next Page

To Previous Page

PTITESFRDEEN

CAUTION

· Do not Autoclave (or any other high temperature Sterilization) Motor Cord.

· Do not lubricate the motor.

· Do not autoclave the motor, even when it is bagged, together with other instruments, from which chemicals are not

sufﬁciently cleaned. This is to avoid discoloration and/or damage to the plating of the motor.

· Do not wash, soak, or wipe off the motor with/in the oxidation potential solution (strong acid, super acid solution) sterilized

solution, strong alkaline solution or functional water.

· The motor is kept in suitable atmospheric pressure, temperature, humidity and ventilation. Moreover, air does not include a

dust, salt and sulfur.

· Do not sterilize with dirt on the surface. It might cause rust.

· You can hang Autoclave Plug on the Hunger Post to prevent loosing it.

· Do not hung the Autoclaving Plug with motor. It may drop the motor and cause damage.

· Do not touch the handpiece just after the autoclave. It may very hot.

· We do not recommend you to sterilize on plasma sterilization or EOG stabilization.

Questions and Answers:

Need help?

Do you have a question about the NSK NLX nano and is the answer not in the manual?

NSK NLX nano Specifications

General