Installation & Operation Manual │ FTG
Abnormal Recycle: Hardware PII INTLK shorted
Abnormal Recycle: Hardware HFS LCI shorted
Abnormal Recycle: Hardware HFS LFS shorted
Abnormal Recycle: Invalid zero crossing
Abnormal Recycle: fault stack sensor
Abnormal Recycle: stack limit
Abnormal Recycle: delta T limit
Abnormal Recycle: fault outlet sensor
Abnormal Recycle: outlet high limit
Abnormal Recycle: fault DHW sensor
Abnormal Recycle: DHW high limit
Abnormal Recycle: fault inlet sensor
Abnormal Recycle: Check Parameters Failed
Internal error: No factory parameters were detected in control
Internal error: PID iteration frequency was invalid
Internal error: Demand-Rate interval time was invalid
Internal error: Factory calibration parameter for modulation was invalid
Internal error: CH PID P-scaler was invalid
Internal error: CH PID I-scaler was invalid
Internal error: CH PID D-scaler was invalid
Internal error: DHW PID P-scaler was invalid
Internal error: DHW PID I-scaler was invalid
Internal error: DHW PID D-scaler was invalid
Internal error: Lead Lag master PID P-scaler was invalid
Internal error: Lead Lag master PID I-scaler was invalid
Internal error: Lead Lag master PID D-scaler was invalid
Abnormal Recycle: Hardware flame bias high
Abnormal Recycle: Hardware flame bias low
Abnormal Recycle: Hardware flame bias delta high
Abnormal Recycle: Hardware flame bias delta low
Abnormal Recycle: Hardware flame bias dynamic high
Abnormal Recycle: Hardware flame bias dynamic low
Abnormal Recycle: Fan Speed Not Proven
Abnormal Recycle: Fan Speed Range Low
Abnormal Recycle: Fan Speed Range High
Abnormal Recycle: Pre-Ignition test failed, recycle
Abnormal Recycle: AC power frequency Mismatch
Modulation rate was limited due to flame strength
Circulator control was invalid
Circulator P-gain was invalid
Circulator I-gain was invalid
Circulator temperature was invalid
Circulator outlet temperature was invalid
Circulator inlet temperature was invalid
Circulator outlet temperature was invalid
To Next Page
Loading...
